Reset printer Epson L210 Error pads full end Life

We have previously seen the L200 Epson printers which gave much to talk positively thanks to the performance and quality of printed pages that can be obtained.
Now the manufacturer has launched Epson printers ink tanks faster and supposedly better performance Epson L210, this team besides being physically similar to Epson L200 within warranty and lifetime does the same as above, when it reaches the 15,000 pages throws an error saying we should replace the pads of this printer, we have to take the Epson support for a solution.

Then we will supply the entire process of how to reset the counter of pages for this type of printer, follow the steps marked from as downloading the file until the complete installation, if you have any problems with the process do not hesitate to contact us, I will gladly help you, use the comments below.

Link to download the reset of Epson L210 printer

It is recommended to download the desktop, the following is to decompress this file, follow the steps below are the installation procedure for the reset function.

Step - 1
When we download the file we will see that this is compressed, we just have to decompress it and in order to do this we need a program, we recommend using Winrar, to know how to perform a decompression see the following instructions on how to unzip a document. see image...

click on Extract and a folder will appear

Step - 2
After we have the decompressed file we double click on the program file that has the following image. It is necessary to run this file and we can do it by double clicking on the right mouse botton and running the file.

Step - 3
A message appears saying that this program is free just click on "accept".

Step - 4
In the next step we have to select the option "Select" on the top right. see image...

click on select

Step - 5
Next the window that lets you select the port to which the printer is connected appears in this we select the "Auto Select" option and click on OK. see image below...

we leave the port in Auto selection mode

Step - 6
In Model Name will appear the name of reset we are trying to install, and then the "Destination" we leave it as shown and in the port we leave the default option in this case is "Auto Selection". See the previous image, if you have a question make a comment.

After we click OK, the window disappears where we selected Auto selection, and the main program window will stay in this moment we have to select the option Particular Adjustment Mode. view image...

particular adjustment mode

Step - 7
In this step we have to be very careful, if we select any other option it can be fatal to our printer, even we can delete the configuration of our printer forever, it is recommended to only select the option that we will tell you.

The option that we have to select is called Waste Ink Pad Counter and we click on OK to continue.

This will restore the printer to tell there is no ink any longer even if this is done we have to know that the residues are full, though perhaps the printer come to think this by the number of pages that have been printed with it, but in reality can cause problems over time.

just click waste ink pad counter

After selecting this option, click on OK.

Step - 8 [End]
Now we select the options that appear to select, after that we click on CHECK to verify that everything is okay, we click on SET, then we click on initialization and then when this process is complete we click on FINISH. After this whole process we turn the printer off, We wait for about 30 seconds and turn it on again, so we have resumed the page counter which used to tell us that our printer had the ink tanks filled. see image.